Instead, keep your phone in a dry area with the charging port facing down. The rice grains can get stuck in your phone’s charging port or headphone jack, especially when the phone is wet and the rice grain expands. You may have seen those online hacks where people put their wet phones on rice. The water particles from your mouth can moisten the charging port and damage your phone. Toothbrush bristles can accidentally get inside the charging port and make matters worse. Here’s what not to do when you’re cleaning your phone: don’t use a toothbrush. Protect Your Phone with a New iPhone 13 Case What Not to Do When Cleaning the Charging Port Avoid getting any moisture inside your phone as well. According to Apple, don’t use any abrasive cleaners like bleach or hydrogen peroxide. You can also try a bulb syringe to remove and loosen debris. Use a soft cotton swab to clean out your charging port. If you’ve noticed issues when charging your phone lately, take it as a sign you may need to clean your charging port, too. When you go to charge your phone, the phone charger can push debris further into the port and then cause problems with charging. While the opening of the charging port seems small, it’s a small and mighty charging port where all sorts of lint and grime can get into. Over time, too much debris in your phone’s charging port can cause your device to stop charging properly or stop working correctly altogether. Things like dust and dirt also end up in your phone’s charging port. You probably also wipe down or sanitize your phone when it gets dirty. You already clean your clothes and wash your dishes. Source: Only_NewPhoto/ Why It’s Important to Clean Your Phone’s Charging Port Here are some tips on how to clean your phone’s charging port. Learn why it’s important to routinely clean your charging port and how to keep your phone clean and protected with a phone case, too. Whenever it turns green in a few seconds, repeat step 4.Whether you have an iPhone or Android, it’s important to keep your phone’s charging port clean. Repeat step 4 again and again till you get a solid red LED that stays red for a longer period of time.It will once again stay red for only a few seconds before turning green. When the LED on the inside of the case turns green, reposition the dead earbud slightly so that the LED turns red again. ![]() ![]() As soon as you place the dead earbuds within the case, the LED on the inside of the case will momentarily turn red, to indicate "charging in progress", and then turn green, to indicate "charging complete" within a few seconds.If both of your earbuds are dead, choose one to revive first and repeat the process with the other later on.This way, the working earbud will not interfere by displaying its own charging status, and the case will report the charging status on only the dead earbud. If one of your earbuds is working, ensure that it has a sufficient charge (ideally 100%) and remove it from the case.Green indicates full battery, but the process should work as long as you know there is sufficient charge in the case. The case has an LED on the outside, and it should light up green when you connect to a power source (wired/wireless). Ensure that there is a sufficient charge on the case.Here are the steps we followed to revive both the dead earbuds on our Galaxy Buds Plus: Trying out the steps on our unit, I can confirm that this does indeed revive dead Buds, but it takes a lot of patience in the process. A guide on Reddit presented instructions on how to fix dead Galaxy Buds.
0 Comments
Leave a Reply. |